Water in oil analysers

Water analysis in Lubrication, Hydraulic, Synthetic and Mineral Oils

Online measurement of water in oil in non hazardous and hazardous environments

Water in oil analysis

JWII can provide water in oil monitoring from EESIFLO. Our sensors monitor water content in oil and fuel around the world. Applications include marine systems, purifiers, engines, oil separators, power plants, metering stations, refineries and oil pipelines. We can also use the sensor as a BS&W analyser for crude oil. The systems are highly robust with EXD ratings cerytified for hazardous environments.

Water analysis in Lubrication, Hydraulic, Synthetic and Mineral Oils

The EASZ- 2 water in oil analyser is suitable for applications involving detection of trace moisture build up and water droplets in hydraulic and lubrication oils. It can also be used for types of mineral or synthetic oil.

The EASZ-2 gives fast and accurate analysis of water content directly inline and can be connected to control systems and alarms that control the operation of an oil dryer or separator. We provide analogue and digital outputs including 4-20mA, Modbus and contacts for alarm relays.

The analyser comes with a backlit display in Green, Amber and Red which is used to indicate different levels of water measured by the sensor. This is useful for operators who can easily see an alarm condition in the process.

The EASZ-2 design allows it to be used for the detection of lower moisture limits in hydraulics and lube and also large amounts of water where leaks or condensation may have occurred in thew process.

The system response is immediate so there is no lag in alerting operators to process upsets. Using the principle of Dielectric Loss with full temperature compensation and solid state design, means the sensor is fast accurate and reliable. The system is factory pre-calibrated prior to delivery for quick and easy commissioning.

Environmental Specification

  • IP65 rated enclosure
  • Ambient Temperature -20°C to +60°C (-40 to 140 °F) – Relative Humidity up to 95%
  • Storage Temperature -20°C to +60°C (-4 to 140 °F) 

Technical Parameters 

  • Rated Voltage Range 11 – 28 Vdc
  • Power Consumption 1 W
  • Cable Glands NPT . (for cable Ø 13 – 18 mm)
  • Cable Type Ø 13 – 18 mm – 2-core to 5-core
  • Material Body – Die cast aluminium powder coated
  • Sensor Pipe – 316 Stainless Steel
  • Sensor Pipe Connection Threaded G½” – G3”
  • Flanged 1” – 48”
  • PN10 – PN40 (150 – 1500 ANSI) 

Outputs

  • Modbus Digital Communication RS485 – 115200 baud – 
  • Analogue 4 – 20 mA passive or active current loop mode
  • Voltage Out 8 – 14 Vdc
  • Relay Open Collector Output State “0” or “1” (off or on) – Maximum 50 V / 45 mA

Accuracy

  • ± 0.05 %
  • Rate of Temperature Change Maximum 1°C / per minute
  • Water in oil analysis
  • Water in oil monitor
  • Water in oil sensor
  • Water in oil detection
  • Water in oil monitoring system
  • Water in crude oil analyser
  • Cut monitor
  • Water cut meter
  • Water in fuel
  • Water in oil

Send a message

  • This field is for validation purposes and should be left unchanged.

Main Products

Water in oil analysis

Shopping Cart
Scroll to Top